Counter Height Bar Stool » Rogue Engineer

In the house that we are renovating we are planning for a small counter height area to pull up a couple of stools. I knew we needed bar stools and I knew I wanted something a little nicer than a simple bar stool. I wanted to make curved seat bar stool but I knew I didn’t have the tools required to do so. Or so I thought. Then I decided that I could just cut the curved seat out of each board before I assembled it. So that’s what I did, and I think it worked out great. And can you believe it was made out of only three 2x4s and for about $10!

Bookmark(0)

No account yet? Register


Do you have 10 seconds? Show this DIY to your friends and fans.



To report this post you need to login first.
No comments