How To Make Miter/Bevel joints that aren’t 90 degrees – Woodworking Tips – YouTube

In this woodworking tip video I show how to make miters and bevels on a table saw that aren’t 90 degrees. I guess technically these are bevels…but people commonly refer to them as miters, so I’m sticking with it. I can’t remember where I learned this trick but I use it quite a bit. The cool thing about it is that it takes a lot of the human error out of trying to perfectly dial in 2 different angles on your saw. It also allows you to make cuts that wouldn’t be possible normally, as running the piece horizontally and vertically provides the same functionality as a saw that could tilt 90 degrees, instead of the normal 45.


No account yet? Register

Do you have 10 seconds? Show this DIY to your friends and fans.

To report this post you need to login first.
No comments