Making A Flat-Pack Plywood Side Table With My New X-Carve And Review – YouTube

This was my first time using my X-Carve or routing anything on a CNC on my own. I found my way through, and it has me excited about the possibilities this is going to open up! In addition to going over my first project with the X-Carve, I also give my initial impressions of setting up the machine and familiarizing myself with Easel, the software the X-Carve runs off of.


No account yet? Register

Do you have 10 seconds? Show this DIY to your friends and fans.

To report this post you need to login first.
No comments